Conventional Fire Alarm

Conventional Fire Alarm is a cheaper alternate for SMALL & Medium enterprise. Convectional Fire Alarm operates on Zone modes. Each Zone we can connect up to 35 Detector. The Conventional Fire Alarm can only give fire indication zone wise, but cannot pip point the exact location , hence its used only Small and Medium enterprises. We Deal with Below Brands for Conventional Fire Alarm System.

Ravel 2/4/8 Zone Conventional Panel

Ravel 2/4/8 Zone Conventional Panel

The microprocessor based 2/4/8 Zone CE mark conventional fire alarm control panel is a standalone system, with 16 X 2 LCD character, 2/4/8 zones detection circuit,3 common potential free contacts & a common NAC sounder output, wall/ceiling mounted, Switch mode power supply- SMPS & Battery polarity & Deep discharge protection.

Ravel Smoke / Heat / Multi Detector

  • UL listed.
  • Dual LED’s for 360° visibility.
  • Advanced detection and communication protocol.
  • Easy installation and maintenance.
  • Sleek low-profile housing design.
  • Regular 100mm base.
Ravel Smoke / Heat / Multi Detector
Manual Call Station

Manual Call Station

  • Alarm status is indicated By Red colour LED.
  • Operates on 24 VDC.
  • Green Colored for Emergency Release.
  • Yellow Colored for Abort.
  • 1 No’s of CO & NC Output (Optional).

NOTIFICATION DEVICE

Sounder with Strobe
  • Easy to install.
  • Operates on 24VDC
  • 100db at 30cm.
  • Low Current.
  • Ceiling/ Flush Wall Mount.
Notification Device
FRLS Armoured Cable

FRLS Armoured Cable

The Fire alarm System we normally use Fire Resistance Cable.
We have brands like Polycab / Finolex / Ashirvad etc.
QUICK ENQUIRY

Enter your contact details,
we will call you back.